CONVERSION
Metres to feet converter
Convert metres into decimal feet, feet-and-inches, centimetres, inches, yards and miles for building, travel and everyday measurement.
Neutral presentation is active.
No regional currency, unit or language profile is applied. This choice does not convert values or change formulas, results, routes or legal guidance.
Feet and inches
5 ft 10.87 inDecimal feet: 5.9055 ft- Centimetres
- 180 cm
- Total inches
- 70.87 in
- Yards
- 1.9685 yd
- Miles
- 0.001118 mi
Save useful calculators here for a quick return. Nothing is sent to an account or server.
Verification and calculation details
- Purpose
- Metres to feet converter
- Variables and units
- Use the labelled fields and units shown in the calculator. Results use those units unless a conversion is stated.
- Formula and method
- The exact formula and worked example are shown below. Deterministic formula executed locally in the browser.
- Assumptions
- Only entered values and stated assumptions are included. Local fees, rules and professional requirements are excluded unless explicitly shown.
- Engine version
- 1.0.0
- Production verification baseline
- Release 63 · source
998803f - Verification run
release-v63-2026-09-20- Last verified
- — Automated release checks passing
Read the Calculation Standard · Report a calculation or source issue
How this calculator works
Feet = metres × 3.280839895013123. Inches = metres × 39.37007874015748. Centimetres = metres × 100.
Variables and inputs
- Metres
- Required numeric input. finite numeric value; calculator-specific validation applies.
How to interpret the result
The calculator returns decimal feet, feet and inches, centimetres, inches, yards and miles. Read each output against the assumptions you entered, compare alternatives one variable at a time, and use the result as an estimate rather than a promise.
Common mistakes to avoid
- Mixing units or entering a rate as a decimal when the field requests a percentage.
- Rounding intermediate values instead of the final displayed result.
- Leaving out a cost, timing rule or local requirement listed in the assumptions below.
Practical uses
Use the metres to feet converter to check a real scenario, compare a changed assumption and explain the arithmetic before relying on a quote, specification or decision.
Worked example
Using exact international factors, 1.8 metres equals approximately 5.9055 decimal feet, 5 feet 10.87 inches, 180 centimetres, 70.8661 inches or 1.9685 yards.
Assumptions and limitations
- the input is a linear length expressed in metres
- international inch, foot, yard and mile definitions are used before display rounding
- results are estimates; confirm rates, prices, units and professional requirements that apply
Important notes
Results are estimates based on the values entered. Confirm rates, prices, units and professional requirements that apply in your location. Review the Answer Atlas Calculation Standard and corrections policy for formula, privacy and correction rules.
Frequently asked questions
Is this a metres to feet or feet and inches converter?
Both. It shows decimal feet and the everyday feet-and-inches format at the same time.
Can I use decimals such as 1.75 metres?
Yes. Decimal metres are supported and converted with exact international length factors.
Does the converter send my measurements anywhere?
No. Length conversion runs in your browser and does not transmit the number you enter.